Nordväl PMPC01 Hardwire kit Micro USB 3-wire

Nordväl PMPC01 Continuous power supply Micro USB to use your Nordväl dashcam in parking mode. This handy continuous power supply is specially designed to connect and use the dashcam in a professional way in the parking position.

3-wire

This Nordväl PMPC01 power supply is a 3-wire 'hardwire kit' that connects to three points, preferably at the fuse box of the car. The yellow cable is connected to a fuse that supplies continuous current (even when the ignition is switched off), the red cable to a switched fuse (which only supplies one current when the ignition is switched on) and the black cable to earth. In this way, the power supply sends a signal to the dashcam when the ignition is switched on and off so that the dashcam will automatically switch to park mode.

Battery protection

The power supply has a built-in protection that cuts the power at a voltage of 11.6V/23.2V or lower. That way the car battery is not overcharged and the dashcam switches off when the voltage gets too low. It is suitable for 12V and 24V vehicles.

Installation

View on this page the detailed instructions on how to install this Continuous Power Supply. This continuous power supply already has a Mini/ATS fuse on both cables as standard. If your car uses this type of fuses and you still have two free spots (continuous one switched) you can simply place these fuses in there. If your car does not have Mini fuses óor you no longer have suitable free spots, you will still have to use a fuse holder. You then cut the Mini fuses off the cable and place the stripped end in the casing of the fuse holder (see step 5 during installation).

Specifications

Length: 3.0m (Plug -> 2.5m -> Inverter > 0.5m -> Fuse/Battery).
Plug: Micro USB
Input: 12V/24V
Output: 5V 3.0 A
Battery protection: 11.6V/23.2V
Type: 3-wire

NOTE: The cable must be connected in the fuse box of the car, this always entails the risk of damage or fire. The installation of this accessory is at your own risk, Dashcamdeal is not liable for damage caused to the car by the installation or use of this accessory. It is also recommended to inquire at your car dealer about the possible lapse of warranty due to or after connection of this power supply.