Nanocam NH03 continuous power supply USB-C 3-wire

This Nanocam NH03 USB-C 3-wire continuous power supply is an intelligent power supply for, among others, the Nanocam M27 and other Nanocam dashcam with USB-C port. This continuous power cable connects to your car's fuse box after which the Nanocam's automatic parking mode can be used.

Variable battery protection

The power supply has a built-in module with a switch that ensures the car's battery does not run down from filming with the dashcam. The switch can be set to 11.8V/23.6V, 12.0V/24.0V, 12.2V/24.4V or 12.4V/24.8V. Power is cut off when the battery voltage falls below the set threshold.

Automatic parking mode

Because this Nanocam power supply is connected to two different power points (one constant and one switched), the dashcam senses when the car ignition is turned on and off. As a result, it automatically goes into parking mode when the car ignition is turned off and starts regular recording again when the car is started.

Installation

View detailed instructions on how to install this continuous power supply on this page.

Four types of Add-a-fuse plugs included

Connecting the power supply is made even easier as 4 types of add-a-fuse plugs are included. This way, only the fuse needs to be replaced for one of these plugs. This is a lot safer than having to plug wires into an existing fuse.

Specifications

Length: 3.5m (Plug -> 2.5m -> Inverter > 1.0m -> Fuse/Accu).
Plug: USB-C
Input: 12V/24V
Output: 4.7V 1.5A
Battery protection: 11.8V-12.4V
Type: 3-wire