Anytek T12+ Full Mirror 2CH
- 1080p + 720p
- 170˚ lens
- 9.66" IPS touch screen
- Fully digital mirror
Digital mirror design
This high-end Anytek T12+ Full Mirror 2CH is a special kind of dashcam, functioning as a complete digital rear view mirror. The whole surface of the mirror also functions as a 9.66 inch touch screen LCD. The video of the front and rear camera can both be shown on this screen. When the rear camera is shown in full there is no interior visible in the mirror resulting in a clearer view. With a simple 'swap' on the screen you can switch between the front and rear camera.
Waterproof rear cam and parking assistance
The 720p rear camera is waterproof and can be installed on any location. It is connected to the front camera using the 6 meter long cable that's include. When it's additionally installed to the power of the reverse light of the car, the rear camera will show on the screen in full once the car is put in reverse. This makes the T12+ Full Mirror 2CH ideal to use as a parking assistance
FullHD 1080p + 720p videos
This Anytek T12+ Full Mirror 2CH records in high quality FullHD 1080p 30fps on the front and 720p 30fps on the rear. Because of the excellent quality of both cameras this mirror dashcam functions very well as a complete digital mirror.
The Anytek T12+ Full Mirror 2CH has two types of parking mode that have to be manually activated. Note that for these functions to properly work the T12+ Full Mirror 2CH has to be powered with the Hardwire Kit (see accessories).
Activate the Motion Detection function in the menu and the camera will stay in stand-by mode. When a motion is detected, the T12+ Full Mirror 2CH will start a recording of 30 seconds and then go in stand-by mode again. Please note that this is a different recording type and is preferably only turned on during parking and turned off when normally driving.
When Parking Mode is activated and the camera is turned off, it will boot up and start a recording when a vibration is detected.
Rubber stap mount
This T12+ Full Mirror 2CH can be easily placed over the existing rear view mirror and is tightened using the provided rubber straps.
128gb Micro SD support
This Anytek T12+ Full Mirror 2CH supports Micro SD cards up to 128gb (not included). 128gb stores about 16 to 24 hours of FullHD 1080p 30fps recordings.
170˚ + 140˚ lens
The Anytek T12+ Full Mirror 2CH has a 170˚ wide view ‘fish-eye’ lens on the front and 140˚ at the rear to make sure a big area around the car is visible and captured.
Anytek T12+ Full Mirror 2CH has a small 500mAh built-in battery for safety reasons. The battery makes sure that the current recording can be saved on the SD card in case of a current power loss.
Note that it’s not the purpose of the battery to power the dashcam for a longer time, the battery doesn’t have enough capacity. Every dashcam should therefore always be connected to a power source in order to function properly.
This Anytek T12+ Full Mirror 2CH is equipped with loop recording so the dashcam will keep recording even when the SD card is full. Videos are stored in short files of 3, 5 or 10 minutes, when the SD card is full the oldest file will be automatically deleted so there is space for a new file. This way you are sure the last period of time is stored on the SD card, the length of this period depending on the size of the SD card.
When powered by the cigarette power plug, the Anytek T12+ Full Mirror 2CH will start recording automatically when the car is turned on and will stop recording when the car is turned off. Note that this function will only work in cars that provide power trough the cigarette port when the ignition is on. When power is also provided when the ignition is off, the T12+ Full Mirror 2CH will stay on and has to be turned on and off manually.
The built-in G-sensor in this Anytek T12+ Full Mirror 2CH registers when you have an accident and in that case saves the current file in a special emergency folder on the SD card. Files in this folder cannot be erased by the loop recording.
This Anytek T12+ Full Mirror 2CH has a built-in microphone. The microphone can be muted in the menu.
Date and time registration
The current time and date of the recordings are visible in the lower corner of the videos. This setting can also be turned off in the menu.